Disabling Spanning Tree Protocol (STP) can cause Broadcast Storms and Layer 2 Switching Loops, which can make your network down within a short span of time.

Note: Never disable Spanning Tree Protocol (STP) if there is no valid reason to disable it. To disable Spanning Tree Protocol (STP) on an IOS based switch use 'no spanning-tree vlan vlan_number' command from global configuration mode as shown below. A VLAN is a switched network that is logically segmented by function, project team, or application, without regard to the physical locations of the users. To enable Spanning Tree Protocol (STP) on an IOS based switch, use the 'spanning-tree vlan vlan_number' command from global configuration mode as shown below.Įnter configuration commands, one per line. This is how to configure VLAN on Cisco Switch or Virtual LAN on Cisco Switches in your network.

It is possible to disable or enable the Spanning Tree Protocol (STP) when required. GitHub - imsiddhant/MY-CCNA-Prep-1: Im currently preparing for my CCNA 200-301 Exam. I hope, these labs will help you too during your preparations. During this preparation, I build some labs on various topics of Networking with the help of Cisco Packet Tracer. Spanning Tree Protocol (STP) is enabled by default on modern switches. 1st July 2020 22nd February 2021 B.ZAMAN Leave a Comment on How to Configure Spanning Tree Protocol on Cisco Switch EXPERIMENT No-10 OBJECT: Simulation of Spanning Tree Protocol.REQUIRED SOFTWARE: Cisco Packet Tracer 7.3. Im currently preparing for my CCNA 200-301 Exam.

Packet tracer labs spanning tree